Table of Contents
Advertisement
Check the position of the chassis latches. The system
board is secured when the latches are parallel with the
outside edge of the board.
5. Hook the tabs of the left side bracket into the slots on the
front left edge of the chassis. Fit the back edge of the
bracket over the back edge of the chassis. Secure the
bracket to the chassis with the screws.
6. Replace the cover (see "Replacing the Small Desktop or
Desktop Cover").
Removing the System Board — Minitower
Use this procedure to remove the system board from a
minitower system.
1. Remove the left side cover (see "Removing the
Minitower Side Covers").
2. Swivel the two feet inward, out of the way.
3. Position the system unit on its right side, with the open
left side facing up.
4. Open the chassis floor for access to the system board and
to unplug the system board from its connector on the riser
board (see "Opening the Chassis Floor").
5. Grasp the two handles on the board and carefully pull the
board straight out of the chassis.
6. Set the board on an antistatic surface.
5-48 Installing Options
Advertisement
Table of Contents
