Removing The System Board And Support Plate Assembly - NEC POWERMATE 2000 Service And Reference Manual

Carefully unplug the following cables from the system board. Do not pull on the cables. Use
10.
a steady pull on the cable connector to release it from its connector on the system board.
LCD panel interface cable from connector P11
!
LCD speaker cable from connector P12
!
auxiliary cooling fan cable from connector P23.
!
Remove the system board and support plate assembly from the system unit chassis and set
11.
the assembly on a clean, smooth static free surface.
If you are removing the processor assembly, network board, or LCD panel, you do not
!
need to remove the support plate from the assembly. (See the device removal
procedures later in this section.)
If you are removing the PC card bay, you need to remove the support plate (see "PC
!
Card Bay Removal" later in this section for procedures).

Removing the System Board and Support Plate Assembly

A – Support Plate
B – System Board
C – Standoff (1)
D – Screw (1 of 6)
Disassembly and Reassembly 3-11