SMC Networks 6608M INT User Manual page 10

FCC - Class A
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause
interference to radio communications. It has been tested and found to comply
with the limits for a Class A computing device pursuant to Subpart B of Part 15
of FCC Rules, which are designed to provide reasonable protection against such
interference when operated in a commercial environment. Operation of this
equipment in a residential area is likely to cause interference, in which case the
user, at his own expense, will be required to take whatever measures may be
required to correct the interference. You are cautioned that changes or modifi-
cations not expressly approved by the party responsible for compliance could
void your authority to operate the equipment.
You may use unshielded twisted-pair (UTP) cable for RJ-45 connections—
Category 3 or greater for 10 Mbps connections and Category 5 for 100 Mbps
connections. Use 50/125 or 62.5/125 multimode fiber optic cable for SC or ST-
type connections.
Warnings 1. Wear an anti-static wrist strap or take other suitable measures to
EC Conformance Declaration
SMC contact for these products in Europe is:
SMC (Europe) Limited
1st Floor, Pyramid House, Easthampstead Road
Bracknell, Berkshire RG12 1NS, United Kingdom
This information technology equipment complies with the requirements of the
Low Voltage Directive 73/23/EEC and the EMC Directive 89/336/EEC. It
conforms to the following specifications:
EMC:
An EC Declaration of Conformity in accordance with ISO/IEC Guide 22 and
EN45014 was issued for this product.
Industry Canada - Class A
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus as set out in the interference-causing
equipment standard entitled "Digital Apparatus", ICES-003 of Industry Canada.
prevent electrostatic discharge when handling this equipment.
2. When connecting this hub to a power outlet, connect the field
ground lead on the tri-pole power plug to a valid earth ground
line to prevent electrical hazards.
EN55022 (1988)/CISPR-22 (1995)
IEC 1000-4-2
IEC 1000-4-3 (1995)
IEC 1000-4-4 (1995)
IEC 1000-4-6 (1995)
C
OMPLIANCES
Class A
4 kV CD, 8 kV AD
3 V/m
1.0 kV - (power line)
0.5 kV - (signal line)
3 Vrms
v