RoboLabs Vortex Popcorn Robopop 60 Instruction Manual page 23

6 Cleaning
ALWAYS unplug before cleaning.
•
• DO NOT use excessive water or water jet for machine cleaning. DO NOT spill water on electric
panels or parts. Using excessive water during cleaning can cause short circuit and electric
shock.
• DO NOT immerse machine and/or supply cord into water.
• DO NOT keep supply cord on the floor.
• Internal surfaces are hot. Touching hot surfaces might cause burn. ALWAYS wait until cooled
down before cleaning.
• DO NOT use high alkaline cleaners, sharp items, or abrasives while cleaning.
The purpose of maintenance and cleaning is to keep machine in good condition during all the
lifetime and to meet safety requirements.
6.1 Daily cleaning
1. Unplug the machine.
2. Inspect supply cord, cable plug, and wall receptacle for any damages. In case of found
damages DO NOT use the machine until damaged parts replaced.
3. Clean outer surfaces of the machine with a soft and clean cloth dampened with mild
detergent. Wipe with a clean cloth dampened with water to remove detergent residues.
Let it dry.
4. Remove un-popped kernels and debris from perforated bowl.
5. Remove dust from internal surfaces of the chamber with the means of soft dry clean
cloth. Avoid hard impact to the optical sensor.
6. Clean the mesh screen with a suitable brush or vacuum cleaner.
7. Take out the salt supply tube. Wash salt supply tube with water. Let it dry completely,
before putting back. Failing to do so might cause salt clogging. When installing the tube
back, make sure that the dot mark on the tube is directed straight to you (given that
you stand in front of controls), thus proper angle is provided.
8. Take out crumb tray and empty it; wash the tray to remove grease and dust, let it dry.
22