RoboLabs Vortex Popcorn Robopop 60 Instruction Manual page 17

5 HMI interface
The HMI interface consists a range of screens, that provide ability of controlling and
monitoring of machine operation, changing parameters of operation and settings of the
machine, and also testing of the machine.
5.1 Start screen
Once machine turned on, start screen appears:
There are two program buttons, BUTTERFLY and MUSHROOM, which allow to run the
machine for processing corn from either of two corn bins.
5.2 Program settings screen
Once program button is pressed, a screen with program settings appears:
Here one can change temperature for certain program, and also oil feed rate and salt feed rate
for Butterfly program only. When operated in Mushroom program, no oil and salt are used.
To change the parameters, press MODIFY button, then enter 2325 password (can be changed,
see General settings screen section). ATTENTION! If no button pressed, the machine will
proceed to heating stage automatically in 15 seconds. After this moment you won't be able to
change parameters until machine switches to popping mode.
During operation, the machine maintains the chamber temperature at set value. Due to
different features of used corn and chosen settings, and also nature of complex processes
happening in the chamber, slight temperature fluctuation is allowed (±5 °C).
16