RoboLabs Vortex Popcorn Robopop 60 Instruction Manual page 14

12. To replace full bag of popcorn DO NOT use PAUSE button on the screen. Press SIFTER
push button under the screen. The sifter stops for 20 seconds, and then resumes
rotation. In this time replace full cart with an empty one.
13. To put process on pause or to change the program press PAUSE button; wait until
program buttons appear on the screen. To resume production, press desired program
button.
14. To finish operation, press TURN OFF button. The machine switches to cooling mode,
the display reads 'COOLING'. Note: when operated in Butterfly program, oil and salt will
be turned off with a delay (see Settings section).
15. Wait until the start screen appears. Press and hold TURN OFF button to shut down the
machine. Otherwise, if no button pressed, the machine will be turned off automatically
in 10 minutes.
4.2 Status and error messages
During normal machine operation different notifications may be displayed on the screen.
Below is the list and operator's actions suggested to be taken.
Heating / Popping / Pause / Cooling — Indicates current operation mode.
Load corn in left (right) hopper — Corn sensor has been tripped. Refill the hopper or let the
machine to process kernels left.
Change bag with popcorn — Bag sensor is tripped. Replace the full cart. Failing to do so will
lead to sound alarm activation and machine will automatically go in pause mode shortly.
Oil and salt will start automatically — While Butterfly program in operation, this message
will appear once corn kernels started to be supplied in the chamber. This is a reminder that oil
and salt supply will start after certain time. See 'Oil turn on delay' setting.
Chamber is clogged with popcorn — Machine chamber is equipped with chamber clogging
sensor that watches what is happening in the chamber. Based on the sensor's output, machine
can increase turbine spinning rate automatically in order to blow out excessive stuff out of the
chamber. If it is not sufficient, then sensor trips and machine switches into cooling mode, and
said message can be seen on the screen.
Chamber clogging sensor trips not only in case of actual clogging, but also in case if too small
amount of corn was put in the hopper or corn sensors have been blinded (for purpose or
incidentally). To continue operation, related indicator should be released. See 'OVERLOAD'
indicator in 'General settings screen' section.
Automatic machine disconnection — Machine has been forcedly switched into cooling
mode. Take a look inside through the observation port in the door to make sure that the
chamber is really clogged.
Also this message can be seen upon turning the machine on. To continue operation, tripped
indicators must be released, see 'General settings screen' section.
13