RoboLabs Vortex Popcorn Robopop 60 Instruction Manual page 21

5.6 Testing screen
To enter general settings screen press SETTINGS on the start screen, type 3333 on the screen
keypad, and then press ENTER, the settings screen appears:
In this screen one can check operation of different parts of the machine, and also see the
status of its sensors and so on.
VFD MOTOR RS485 — Turbine on/off.
Y0.SA SIFTER — Sifter on/off.
Y1.SA OIL PUMP — Oil pump on/off.
Y2 CORN FEED.L — Left corn feeder (Butterfly) on/off.
Y3 CORN FEED.R — Right corn feeder (Mushroom) on/off.
Y3.SA SALT FEED — Salt auger on/off.
Y4.SN SALT FAN — Salt blower on/off.
DTC1000_RUN — Heaters on/off.
NOTE 1: Heaters can be turned on only when turbine (VFD MOTOR RS485) is on.
NOTE 2: During testing mode heaters work at 100%, without PID regulation, so one should
control the temperature in the chamber to avoid overheating.
PROBE TYPE K — Temperature sensor type change (type K or Pt100).
Y5.SN BUZZER — Buzzer on/off.
VFD — Adjusts speed of turbine rotation. Effective only while in this screen, it does not affect
the turbine speed set in general settings screen.
20