Icom IC-706 MKII Instruction Manual page 49

fl SLAY tig LIT (scan resume)
This item sets the scan resume function ON or OFF.
ON: scan resumes 10 sec. after stopping on a signal
(or 2 sec. after a signal disappears); OFF: scan does
not resume after stopping on a signal. For the priori-
ty watch, setting to OFF pauses the watch until sig-
nal disappears and scan resumes.
(scan speed)
This item sets the rate at which channels or frequen-
cies are scanned during scan operations. High or low
can be selected.
"Es EL! (up/down speed)
This item sets the rate at which frequencies are
scanned through when the [UP]DN] switches are
pushed and held. High or low can be selected.
The optional AT-180 ANTENNA TUNER has an auto-
matic start capability which starts tuning if the SWR
is higher than 1.5-3.
When "oFF" is selected, the tuner remains OFF even
when the SWR is poor (1.5-3).
When "on" is selected, automatic tune starts even
when the tuner is turned OFF.
When an optional AH-3 ANTENNA TUNER is connect-
ed, tuning can be started automatically at the
moment the PTT is pushed.
DEH
This item sets the number of memo pad channels
available. 5 or 10 memo pads can be set.
mE a I ei (quick split function)
When this item is set to ON, pushing [FL] for 2 sec.
sets the undisplayed VFO frequency to the displayed
VFO frequency plus the split offset or duplex offset,
and activates split operation.
a Ta |
Scan resume function is
turned ON (default).
Scan speed is set to high
(default).
Up/down speed is set to
high (default).
mt
Auto tune function OFF
(default).
SETMODE 7
-E
mt
Scan resume function is
turned OFF.
LI
Scan speed is set to low.
, -
hor
Up/down speed is set to low.
a]
Auto tune function ON.
Note: Even when "on" is selected, automatic tune
does not start for the 50 MHz band.
Poy Sa
mnt
Tuning starts only when
[TUNER] is pushed (default).
5 memo pads are available
(default).
me
Quick split function ON
(default).
Pe |
Tuning starts when pushing [PTT]
on anew frequency.
"ea
Quick split function OFF.
46