Icom IC-706 MKII Instruction Manual page 47

T SETMODE
-T i] (SSB only)
This item adjusts the carrier frequency (BFO frequen-
cy), allowing you to change the audio characteristics.
Selectable values are —200 to +200 Hz in 10 Hz steps.
SEWING (tty ony)
This item adjusts the RTTY keying. Normal or
reverse keying can be selected. =
This item selects a subaudible tone for FM-T mode
operation to access a repeater. There are 50 tones
available from 67.0 Hz to 254.1 Hz (see table at
right).
In addition, there is a 1750 Hz tone burst function
available for European repeaters. When "1750" is
selected, [(F-3) T Ut] in t4 transmits a tone burst sig-
nal during transmission.
AGCLE won
This item adjusts the CW paddle type. Four selec-
tions are available.
en : normal (for electronic keyer use)
er : reverse (for electronic keyer use)
°OFF : Turns OFF the electronic keyer (for
straight key use)
: For using the microphone's [UP]/[DN]
keys instead of the CW paddle.
. (FM only)
This item adjusts sets a subaudible tone for tone
squelch use. (the same subaudible tone frequencies
as for repeater operation are available—see above).
mE ET (CW only)
This item adjusts the CW key speed. The key speed
can be selected from 6 to 60 wpm.
REET TCI (ew only)
This item adjusts the CW key ratio (or weight). The
ratio can be selected from 2.8 to 4.5.
PANEL DESCRIPTION 1
The default is 0 Hz.
The default is "n," normal.
Normal : key open=mark
Reverse : key open=space
225.7 | 254.1
The default is "n," normal.
The default is 88.5 Hz.
The default is 20 wpm.
The default is 3.0.
44