Icom IC-706 MKII Instruction Manual page 22

19
3 FREQUENCY SETTING.
e Quick band change function
The quick band change function automatically stores
the last frequency and mode used for each band ina
band stacking register. This is convenient for contest
operation, etc. The table at right shows the quick
band change default settings for each band. Display shows the
© Select 33. . default bands for the
e Push [DISPLAY] when M or G is displayed. sete change
e Push [MENU] twice to select 53.
@ Push [F-1]-[F-3] to select a band stacking register. 4
¢The default settings for [F-1]-[F-3] are 7, 50 and 144
MHz bands, respectively. 7
@®To change the settings for [F-1HF-3] from their Display shows [F-2]
defaults, push [F-1]-[F-3] for 1 sec. one or more has been changed from
times to until the desired band appears in the dis- its default of the 50 MHz
play above the corresponding switch. ` band to the general
[BAND [FREQUENCY | MODE [FREQUENCY | WODE |
15.10000 MHz 144 MHz 145.00000 MHz
*General refers to the general coverage receiver (GEH in
the display) and the range varies according to version.
E Mode selection
The following modes are available in the IC-706MKII:
SSB (LSB/USB), CW, CW- (CW reverse), FM, OPERATING MODE SELECTION
WFM (receive only), AM, RTTY and @RTTY (RTTY
reverse). Push
To select the desired mode of operation push momentarily
[MODE] one or more times, then push [MODE] for 2
sec., if necessary. See the diagram at right for the Push
order of selection.
e The selected mode is indicated in the function display. for 2 sec.
Note: If a desired mode cannot be selected, it may be
hidden using Quick Set mode (p. 43).