5
MEMORY AND SCAN OPERATION
E Scan types
PROGRAMMED SCAN
Repeatedly scans between two scan edge frequencies
(scan edge memory channels P1 and P2).
4 Scan edge P2 or P1 2
Scan edge P1 or P2 À
This scan operates in VFO mode.
MEMORY SCAN
Repeatedly scans all programmed memory channels.
S (select)
S (select)
s (select)
This scan operates in memory mode.
E Preparation
e Channels
For programmed scan:Program scan edge frequen-
cies into scan edge memory channels
P1 and P2
(p. 33).
For memory scan:Program 2 or more memory chan-
nels except scan edge memory channels.
For memory select scan: Designate 2 or more memo-
ry channels as select memory channels—select a
memory channel, then push [(F-2) ŻEL] in the 5 dis-
play (memory mode) to designate the channel as a
select memory channel.
For priority watch: Program 1 memory channel to be
watched.
e Scan resume ON/OFF
You can select the scan to resume or cancel when
detecting a signal, in initial set mode, item 9. Scan
resume ON/OFF must be set before operating a scan.
See p. 46 for ON/OFF setting and scan resume con-
dition details.
PRIORITY WATCH
Checks for signals on a memory or call channel while
operating on a VFO frequency.
This scan operates in VFO mode.
SELECTED MEMORY SCAN
Repeatedly scans all selected memory channels.
S (select)
This scan operates in memory mode.
e Scan speed
Scan speed can be selected from 2 levels, high or low,
in initial set mode. See p. 46 for details.
e Squelch condition
| The scan continues
until it is stopped
Scan pauses on each
;
channel when the
| manually, and does
| scan resume is ON;
| not pause even if it
not applicable when
| detects signals.
OFF.
| This is not applicable
| when the scan
| resume is OFF anda
| programmable step
| (more than 1 kHz) is
| selected.
| Scan stops when detecting a signal.
| If you set scan resume ON in initial set mode,
| the scan pauses for 10 sec. when detecting a
| signal, then resumes. When a signal disap-
| pears while scan is paused, scan resumes 2
1 sec. later.
Need help?
Do you have a question about the IC-706 MKII and is the answer not in the manual?
Questions and answers