Commissioning - Panasonic WEB-SERVER II Technical Description

Hide thumbs Also See for WEB-SERVER II:

14. COMMISSIONING

This chapter describes the correct sequence to install and set the web-server.

NOTE! Make sure to read the complete technical description before commissioning the system.

PREPARATIONS AND MOUNTING

a) Mount the web-server on the DIN rail inside the c.i.e. for system EBL512 G3 and EBL128. For

system EBL512 mount the web-server outside the c.i.e. on a symmetric 35 DIN rail. The length of

the attached cables is 3 meters.

CONNECTIONS

b) Connect the cables according to

SETTING OF IP ADDRESS AND CONFIGURATION

c) Set the IP address with Chiptool, see chapter

d) Download the EBL software, see

e) Download the EBLWeb configuration, see

f) Download the SSD to the web-server.

TECHNICAL DESCRIPTION 1598 • DOCUMENT NUMBER: MEW01930 • REVISION: 4

13. INSTALLATION AND WIRING

8 ADVANCED CONFIGURATION

7.1.1. DOWNLOAD EBLWEB SOFTWARE

7.2.1. DOWNLOAD EBLWEB CONFIGURATION

Table of Contents

Do you have a question about the WEB-SERVER II and is the answer not in the manual?

Fp-web2