Unit Settings; Dns Setting; Ntp Settings; Event Log - Panasonic WEB-SERVER II Technical Description

6. CONFIGURATION OF EBLWEB

6.1.3. UNIT SETTINGS

IP ADDRESS SETTING
Use DHCP: Select this option when a dynamic IP number shall be used (instead of a static, see below).
Device name: It is always recommended to have a device name, not only when a dynamic IP number is
used.
If a static IP number shall be used the following data have to be specified:
• IP address (for web-server)
• Netmask
• Gateway

DNS SETTING

Use DNS: Select this option when Domain Name Server shall be used. DNS is used to translate hostnames
into IP addresses.
Primary DNS: The IP address to the primary DNS
Secondary DNS: The IP address to the secondary DNS

NTP SETTINGS

Normally the c.i.e. no. 00 in an EBL512 G3 system will send out the date & time every day at midnight, to
synchronize the clock in all c.i.e in the system as well as the clock in Web-server II.
For continuous correct time and synchronization of all the clocks an NTP server can be used. In this case,
synchronization will be done one hour after midnight every day.
NTP server: The NTP server's IP address. If DNS is selected (see above) the server name is used instead.

EVENT LOG

All the events in the EBL-system will also be stored in the web-server internal RAM. In case of a power-loss
(or unexpected reboot), the event log will be lost.
Daily log save: The event log will be automatically saved to flash memory once every day (one hour after
midnight).
FTP/TELNET ACCESS
When the Web-server shall be configured (programmed) via the PC tool, this will be done via FTP/Telnet
via a LAN network (or crossed Ethernet cable or a hub). For safety reasons, username and password are
used for FTP/Telnet. The default username/password is ftp/ftp, but this can be changed.
New username: Type the new username.
New password: Type the new password. (Only dots will be displayed.)
Confirm password: Re-type the new password once more. (Only dots will be displayed.)
NOTE! The new username and password will not be valid until after download and restart of the Web-
server.
TECHNICAL DESCRIPTION 1598 • DOCUMENT NUMBER: MEW01930 • REVISION: 4
12