Mounting The Drip Stand; Tilt Scale Backrest - Invacare Rea Azalea Assist Service Manual

Rea® Azalea®
3.
F
Mount the push bar E in the backrest tubes and tighten
the handwheels C.
WARNING!
Risk of injury
The push bar can loosen from the attachments.
— Make sure that the marking F on the
tubes are fitted against the backrest tube.
Check that the handwheels can be
tightened properly, the screw of the
handwheel should barely be visible. If the
push bar is in the wrong position, the
handwheel will not be possible to tighten
properly.
4.
A
B
Re-mount the brake handles B and tighten the screws A.
Torx driver T20
3.3 Mounting the Drip stand
WARNING!
Risk of tipping / injury
— Max load on the drip stand: 4 kg (2 x 2 kg).
The rod of the drip stand must always be placed in a
vertical position, i.e in a 90 degree angle to the
ground, no matter the position of the backrest or the
wheelchair.
7
E
C
A
1.
A
Mount the holder for the drip stand A on the neckrest
holder and tighten the screw B
5 mm Allen key
2.
C
D
Mount the lever C, the washers D and the holder with
the drip stand E in the attachment and tighten the lever.
3.4 Tilt scale backrest
1.
A
C
Attach the clamps A with the tilt scale C to the push
bar/push handles or the backrest tubes and tighten the
screws B.
2.
Place the end plugs D in the empty holes.
3.
B
E
B
D
D
1580313-K