ZyXEL Communications ZYWALL USG 2000 Support Notes page 22

the connection (phase1 and phase2). The purpose for this policy route is to tell the
ZyWALL USG 2000 to send the traffic to the VPN tunnel when the traffic goes from the
local subnet to the destination that is in a remote subnet. Switch to Network> Routing >
Policy > Policy Route and add a new policy route, the source and destination address are
the local and remote subnet and the Next-Hop type is a VPN tunnel. Then choose the
corresponding VPN connection rule from the VPN tunnel drop down menu. Now, the VPN
tunnel and routing is built and user can start to test it.
9) After configuring both sides of the VPN, click the "Dial up" icon to test the VPN
connectivity.
10) "VPN tunnel establishment successful," message appears.
All contents copyright (c) 2008 ZyXEL Communications Corporation.
ZyWALL USG 2000 Support Notes
8
22