ZyXEL Communications ZYWALL USG 2000 Support Notes page 204

forward <Original IP(ex. WAN1's IP):8080> to <Internal server IP:8080>.
F04. After I installed a HTTP proxy server and set a http redirect rule, I still can't
access web. Why?
Your proxy server must support a transparent proxy. If your proxy does have this feature, turn
it on. For example, for Squid, you have to have the option httpd_accel_uses_host_header
enabled.
F05. How to limit some application (for example, FTP) bandwidth usage?
In order to restrict the bandwidth usage for a specific application, you need to employ
AppPatrol feature.
The following steps allow the user to limit the bandwidth usage from of FTP application:
1. Pick up the FTP application that you want to restrict bandwidth usage and click "Edit" in
AppPatrol > Common page.
2. Click the "Edit" button for default policy, and the "Configuration" page appears.
3. On the "Configuration" page, enter the bandwidth amount you want to limit bandwidth
usage in direction "Inbound" or "Outbound".
4. Back to "General" page under AppPatrol and check the "Enable BWM" checkbox then
click the "Apply" button to complete the entire configuration.
Note. On the ZLD 1.0 the default setting of bandwidth management is ON and you cannot
change the setting, but on the ZLD 2.0 the default setting of bandwidth management is off,
therefore if you are upgraded from 1.0 to 2.0, the "Enable BWM" checkbox will be checked.
F06. What's the routing order of policy route, dynamic route, and static route
and direct connect subnet table?
All these routing information create the ZyWALL USG 2000 routing database. When routing,
ZyWALL USG 2000 will search with the following order:
1. Local and direct connect subnet table.
2. Policy route rule.
3. Main table, which includes routes learned from RIP/OSPF, static routes and default
routes.
All contents copyright (c) 2008 ZyXEL Communications Corporation.
ZyWALL USG 2000 Support Notes
204