The Static Route Screen; Figure 123 Advanced > Static Route; Table 78 Advanced > Static Route - ZyXEL Communications P-660HN User Manual

Chapter 13 Static Route

13.2 The Static Route Screen

Use this screen to view the static route rules. Click Advanced > Static Route to open the
Static Route screen.
Figure 123 Advanced > Static Route
The following table describes the labels in this screen.
Table 78 Advanced > Static Route
LABEL
#
Active
Name
Destination
Gateway
Subnet Mask
Modify
Apply
Cancel
212
DESCRIPTION
This is the number of an individual static route.
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This is the name that describes or identifies this route.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward
packets to their destinations.
This parameter specifies the IP network subnet mask of the final destination.
Click the Edit icon to go to the screen where you can set up a static route on the
ZyXEL Device.
Click the Remove icon to remove a static route from the ZyXEL Device. A window
displays asking you to confirm that you want to delete the route.
Click this to save your changes.
Click this to restore your previously saved settings.
P-660HN-Fx User's Guide