Table of Contents
Advertisement
Chapter 8 Network Address Translation (NAT)
Figure 73 Network > NAT > Port Forwarding: Edit
The following table describes the fields in this screen.
Table 46 Network > NAT > Port Forwarding: Edit
LABEL
Active
Service Name
Start Port
End Port
Server IP
Address
Back
Apply
Cancel
8.4 The Address Mapping Screen
The Address Mapping screen is available only when you select Full Feature
in the NAT > General screen.
Ordering your rules is important because the ZyXEL Device applies the rules in the order that
you specify. When a rule matches the current packet, the ZyXEL Device takes the
corresponding action and the remaining rules are ignored. If there are any empty rules before
your new configured rule, your configured rule will be pushed up by that number of empty
140
DESCRIPTION
Click this check box to enable the rule.
Enter a name to identify this port-forwarding rule.
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port
number in the End Port field.
Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port field above
and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with
the port number in the Start Port field above.
Enter the inside IP address of the server here.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
P-660HN-Fx User's Guide
Advertisement
Table of Contents
Troubleshooting
