Quality Of Service (Qos); Chapter 15 Quality Of Service (Qos); Overview; What You Can Do In The Qos Screens - ZyXEL Communications P-660HN User Manual

C
H A P T E R

15.1 Overview

Use the QoS screens to set up your ZyXEL Device to use QoS for traffic management.
Quality of Service (QoS) refers to both a network's ability to deliver data with minimum delay,
and the networking methods used to control bandwidth. QoS allows the ZyXEL Device to
group and prioritize application traffic and fine-tune network performance.
Without QoS, all traffic data are equally likely to be dropped when the network is congested.
This can cause a reduction in network performance and make the network inadequate for time-
critical applications such as video-on-demand.
The ZyXEL Device assigns each packet a priority and then queues the packet accordingly.
Packets assigned with a high priority are processed more quickly than those with low priorities
if there is congestion, allowing time-sensitive applications to flow more smoothly. Time-
sensitive applications include both those that require a low level of latency (delay) and a low
level of jitter (variations in delay) such as Voice over IP (VoIP) or Internet gaming, and those
for which jitter alone is a problem such as Internet radio or streaming video.

15.1.1 What You Can Do in the QoS Screens

• Use the General screen
decide allowable bandwidth using QoS and configure priority mapping settings for traffic
that does not match a custom class.
• Use the Class Setup screen
into different flows and assign priority and define actions to be performed for a classified
traffic flow.
• Use the Monitor screen
related packet statistics.

15.1.2 What You Need to Know About QoS

QoS versus Cos
QoS is used to prioritize source-to-destination traffic flows. All packets in the same flow are
given the same priority. Class of Service (CoS) is a way of managing traffic in a network by
grouping similar types of traffic together and treating each type as a class. You can use CoS to
give different priorities to different packet types.
P-660HN-Fx User's Guide

Quality of Service (QoS)

(Section 15.2 on page
(Section 15.3 on page
(Section 15.4 on page
15
229) to enable QoS on the ZyXEL Device,
230) to set up classifiers to sort traffic
234) to view the ZyXEL Device's QoS-
225