The Class Setup Screen; The Class Configuration Screen; Figure 139 Advanced > Qos > Class Setup; Table 84 Advanced > Qos > Class Setup - ZyXEL Communications P-660HN User Manual

Chapter 15 Quality of Service (QoS)

15.3 The Class Setup Screen

Use this screen to add, edit or delete classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port
number, destination port number or incoming interface. For example, you can configure a
classifier to select traffic from the same protocol port (such as Telnet) to form a flow.
Click Advanced > QoS > Class Setup to open the following screen.
Figure 139 Advanced > QoS > Class Setup
The following table describes the labels in this screen.
Table 84 Advanced > QoS > Class Setup
LABEL
Create a new Class
No
Active
Name
Interface
Priority
Filter Content
Modify
Apply
Cancel

15.3.1 The Class Configuration Screen

Use this screen to configure a classifier. Click the Add button or the Edit icon in the Modify
field to display the following screen.
230
DESCRIPTION
Click this to create a new classifier.
This is the number of each classifier. The ordering of the classifiers is important
as the classifiers are applied in turn.
Select the check box to enable this classifier.
This is the name of the classifier.
This shows the interface from which traffic of this classifier should come.
This is the priority assigned to traffic of this classifier.
This shows criteria specified in this classifier.
Click the Edit icon to go to the screen where you can edit the classifier.
Click the Remove icon to delete an existing classifier.
Click this to save your changes.
Click this to restore your previously saved settings.
P-660HN-Fx User's Guide