Configuring Protocol Filter Rules; Figure 102 Security > Packet Filter > Edit (Protocol Filter); Table 62 Security > Packet Filter > Edit (Protocol Filter) - ZyXEL Communications P-660HN User Manual

Figure 102 Security > Packet Filter > Edit (Protocol Filter)
The following table describes the labels in this screen.
Table 62 Security > Packet Filter > Edit (Protocol Filter)
LABEL
#
Active
Filter Type
Protocol
SA
DA
Modify
Back
Apply
Cancel

11.2.2 Configuring Protocol Filter Rules

Use this screen to configure protocol filter rules. In the Edit (Protocol Filter) screen, click an
Edit icon to display the following screen.
P-660HN-Fx User's Guide
DESCRIPTION
This is the index number of the rules in a filter set.
Use the check box to turn a filter rule on or off.
This field displays whether the filter type is a protocol filter or generic filter.
This field displays the upper layer protocol.
This field displays the source IP address.
This field displays the destination IP address.
Click the Edit icon to configure a filter rule.
Click the Remove icon to delete a filter rule.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 11 Packet Filter
179