The Port Forwarding Rule Edit Screen; Figure 72 Network > Nat > Port Forwarding; Table 45 Network > Nat > Port Forwarding - ZyXEL Communications P-660HN User Manual

Figure 72 Network > NAT > Port Forwarding
The following table describes the fields in this screen.
Table 45 Network > NAT > Port Forwarding
LABEL
Default Server Setup
Default Server
Port Forwarding
Service Name
Server IP
Address
Add
#
Active
Service Name
Start Port
End Port
Server IP
Address
Modify
Apply
Cancel

8.3.2 The Port Forwarding Rule Edit Screen

Use this screen to edit a port forwarding rule. Click the rule's edit icon in the Port
Forwarding screen to display the screen shown next.
P-660HN-Fx User's Guide
DESCRIPTION
In addition to the servers for specified services, NAT supports a default server. A
default server receives packets from ports that are not specified in this screen. If
you do not assign a Default Server IP address, the ZyXEL Device discards all
packets received for ports that are not specified here or in the remote management
setup.
Select a service from the drop-down list box.
Enter the IP address of the server for the specified service.
Click this button to add a rule to the table below.
This is the rule index number (read-only).
This field indicates whether the rule is active or not.
Clear the check box to disable the rule. Select the check box to enable it.
This is a service's name.
This is the first port number that identifies a service.
This is the last port number that identifies a service.
This is the server's IP address.
Click the edit icon to go to the screen where you can edit the port forwarding rule.
Click the delete icon to delete an existing port forwarding rule. Note that
subsequent address mapping rules move up by one when you take this action.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 8 Network Address Translation (NAT)
139