Table of Contents
Advertisement
Chapter 4 Internet and Wireless Setup Wizard
Figure 25 Wireless LAN
The following table describes the labels in this screen.
Table 14 Wireless LAN Setup Wizard 2
LABEL
Network
Name(SSID)
Channel
Selection
Security
Back
Next
Exit
The wireless stations and ZyXEL Device must use the same SSID, channel ID
and WEP encryption key (if WEP is enabled), WPA-PSK (if WPA-PSK is
enabled) for wireless communication.
4 This screen varies depending on the security mode you selected in the previous screen.
Fill in the field (if available) and click Next.
62
DESCRIPTION
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless
LAN.
If you change this field on the ZyXEL Device, make sure all wireless stations use the
same SSID in order to access the network.
The range of radio frequencies used by IEEE 802.11b/g wireless devices is called a
channel. Select a channel ID that is not already in use by a neighboring device.
Select Manually assign a WPA-PSK key to configure a Pre-Shared Key (WPA-PSK).
Choose this option only if your wireless clients support WPA. See
page 63
for more information.
Select Manually assign a WEP key to configure a WEP Key. See
page 63
for more information.
Select Disable wireless security to have no wireless LAN security configured and
your network is accessible to any wireless networking device that is within range.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen.
Click this to close the wizard screen without saving.
Section 4.3.1 on
Section 4.3.2 on
P-660HN-Fx User's Guide
Advertisement
Table of Contents
Troubleshooting
