Table of Contents
Advertisement
Chapter 4 Internet and Wireless Setup Wizard
Figure 16 Internet Access Wizard Setup: ISP Parameters
The following table describes the fields in this screen.
Table 8 Internet Access Wizard Setup: ISP Parameters
LABEL
Mode
Encapsulation
Multiplexing
Virtual Circuit
ID
VPI
VCI
Back
Next
Exit
56
DESCRIPTION
Select Routing (default) from the drop-down list box if your ISP give you one IP
address only and you want multiple computers to share an Internet account. Select
Bridge when your ISP provides you more than one IP address and you want the
connected computers to get individual IP address from ISP's DHCP server directly. If
you select Bridge, you cannot use Firewall, DHCP server and NAT on the ZyXEL
Device.
Select the encapsulation type your ISP uses from the Encapsulation drop-down list
box. Choices vary depending on what you select in the Mode field.
If you select Bridge in the Mode field, select either PPPoA or RFC 1483.
If you select Routing in the Mode field, select PPPoA, RFC 1483, ENET ENCAP or
PPPoE.
Select the multiplexing method used by your ISP from the Multiplex drop-down list
box either VC-based or LLC-based.
VPI (Virtual Path Identifier) and VCI (Virtual Channel Identifier) define a virtual circuit.
Refer to the appendix for more information.
Enter the VPI assigned to you. This field may already be configured.
Enter the VCI assigned to you. This field may already be configured.
Click this to return to the previous screen without saving.
Click this to continue to the next wizard screen. The next wizard screen you see
depends on what protocol you chose above.
Click this to close the wizard screen without saving.
P-660HN-Fx User's Guide
Advertisement
Table of Contents
Troubleshooting
