Making Telephone Calls - NetComm NB9WMAXX User Manual
Adsl2+ voip modem router
Hide thumbs
Also See for NB9WMAXX:
- Quick start manual (17 pages) ,
- Mac user manual (13 pages) ,
- Specifications (2 pages)
Table of Contents
Advertisement
Making Telephone Calls
To make a call, simply dial the number.
To dial an IP address directly, dial the IP address digits, using keypad * as the dot. Complete the address with
a final * or #. When using IP address dialing it is not possible to specify which line at a gateway is called, so
the gateway always routes IP-address dialed calls to the first line.
Network busy tone (fast busy) will be played for unknown or unreachable destinations.
To answer calls, simply pick up the phone or press the handsfree button.
Call Hold
To put a call on hold, press flash then hang up (optional). To return to the original call, press flash or pick up
the phone. The phone will issue a short ring burst every 30 seconds or so while on-hook to remind you that a
call is on hold.
Call Transfer
•
To transfer a call, press flash then dial the new number.
•
To transfer immediately, hang up (blind transfer).
•
To transfer with consultation, wait for the party to answer, consult, and then hang up.
•
To abort the transfer (if the third party does not answer), press flash to return to the original call.
Conference Calling
To turn a two-party call into a three-party conference call, press flash and dial the third party. Wait for the
party to answer, then press flash.
To drop the third party and return to a two-party call, press flash again. To drop yourself out of the
conference, hang up. The call will be transferred (so that the other two parties remain connected to each
other). In conference mode, the conference initiator performs the audio bridge/mixing function – there are
two voice streams established.
Call Waiting
If call waiting is enabled on a line (see feature codes), and you hear the call waiting tone during a call, press
flash to answer the second call. The first call is automatically placed on hold. To switch between calls, press
flash again.
•
To disable the call waiting feature, dial *60.
•
To enable the call waiting feature, dial *61.
•
Call forward feature settings (Busy or All) takes priority over the call waiting feature.
•
Call waiting feature is ignored on new incoming calls if there is already a call on hold or in conference.
NB9WMAXX ADSL+ VoIP Router
YML89 Rev1
9
Advertisement
Table of Contents
