Connecting The Cables - NetComm NB9WMAXX User Manual

1. Connecting the Cables

Note: If you wish to link to the NB9WMAXX wirelessly at the outset, see Establishing a Wireless Connection below.
1. Connect your PC using Ethernet cable to one of the LAN ports of your NB9WMAXX;
2. Connect the POTS pass-through line ;
i. Connect telephone wall-socket to port on in-line splitter called LIne;
ii. Connect one end of an RJ11 (telephone) cable to Phone port of the in-line splitter and connect the
other end to the LINE port on NB9WMAXX;
3. Connect the ADSL service - connect one end of a second RJ11 (telephone) cable to the ADSL/Modem
port of the in-line splitter and connect the other end to the ADSL port of the NB9WMAXX;
4. Connect the power cable to the Power socket and plug into a power source;
5. Switch your NB9WMAXX on at the powerpoint;
6. Switch on your PC.
Make sure the LAN LED (light) on your NB9WMAXX is on, which indicates that network function is active.
Note that the pass-through service is provided as a back-up and that calls made through this line are not the same VoIP calls and will
be subject to normal telecommunications charges.
The next section explains how to establish your ADSL connection to the Internet.
1 NB9WMAXX ADSL+ VoIP Router
YML89 Rev1