Table of Contents
Advertisement
Additional Product Information
Using the NetComm Wireless 3G27WV-02 to make and receive
telephone calls
The NetComm Wireless 3G27WV-02 provides circuit switched voice services via two telephony line interfaces offering the ability to
make and receive telephone calls via a regular analogue telephone using the mobile network.
Note: Please refer to your mobile service provider for activation of your voice service and information about the call
charges that apply.
It's important to note that the NetComm Wireless 3G27WV-02 has two separate line interfaces that share a single
outbound/inbound telephone line. This means that handset(s) connected via one port will not be able to use the line at the same
time as handsets connected via the other port.
If a call is already in progress via the first port, the user on the handset(s) connected to the second port will receive a busy signal.
Incoming calls will ring and can be answered on either port, however once a call is answered from one port, handset(s) on the
second port will receive a busy signal.
Handset requirements
The NetComm Wireless 3G27WV-02 allows you to make telephone calls over the mobile network using a standard analogue
telephone via the built in RJ-11 Phone ports. Please refer to the documentation provided by the manufacturer of your analogue
telephone for assistance with the operation of your telephone handset.
Maximum REN Loading
Please note that each of the line interfaces on the NetComm Wireless 3G27WV-02 is capable of supporting multiple analogue
telephones connected via splitters. The ringer equivalence number (REN) for each line is 5. Therefore, a maximum of 5 handsets
each with a REN number of 1 can be connected to each line port.
Before you start make any phone call, make sure you have checked the following:
1.
You have an activated SIM card inserted prior to powering on the NetComm Wireless 3G27WV-02.
2.
Your NetComm Wireless 3G27WV-02 is powered on and in running condition.
3.
A working analogue telephone is connected into either the Line 1 or Line 2 port.
4.
You hear the dial tone and the Line LED on the front of your NetComm Wireless 3G27WV-02 should light up after lifting
the handset.
How to place a call
To make a call, simply lift the handset, listen for a dial tone and then dial the number following the instructions provided by your
telephone handset manufacturer.
How to receive a call
When an incoming call is received, both Line 1 and Line 2 lights will start flashing and any phones connected to the NetComm
Wireless 3G27WV-02 will ring. Answer the telephone following the instructions provided by your telephone handset manufacturer
to conduct the call.
Please note: If the call is answered from a telephone connected to Line 1, telephones connected to Line 2 will receive an
engaged tone for the duration of the call.
If there is no phone connected to the NetComm Wireless 3G27WV-02, all incoming calls will be transferred to Voicemail (if
enabled on the device).
Answering an incoming call when on a call
Call waiting enables a 2nd incoming call to be received while you are on a call. To answer a call waiting call, perform a hook-flash
(briefly depressing the hook button). The incoming call should then be answered. Upon hanging up or performing another hook-
flash, you will be returned to the original telephone call.
Accessing voicemail
To access your voicemail, please dial *98 and follow the voice prompts.
www.netcommwireless.com
NetComm Wireless 3G27WV-02 User Guide
64
Advertisement
Table of Contents
