Default Settings; Restore Factory Default Setting - NetComm NB9WMAXX User Manual

DEFAULT SETTINGS

The following are the default LAN (Local Area Network) and WAN (Wide Area Network).
LAN (Management)
• Static IP Address: 192.168.1.1;
• Subnet Mask: 255.255.255.0;
• Default Gateway: blank;
WAN (Internet)
• Empty: Once you have run through 'ADSL Quick Setup' you will have a saved WAN connection;
• Default connection type: PPPoE (most common for Australian ISPs);
• VPI / VCI: 8 / 35;
Modem Access
• Username: admin
• Password: admin

Restore Factory Default Setting

Restore Factory Defaults will reset the NB9WMAXX to its factory default configuration.Occasionsmay present
themselves where you need to restore the factory defaults on your NB9WMAXX such as:
• You have lost your username and password and are unable to login to your NB9WMAXX's web
configurationpage;
• You have purchased your NB9WMAXX from someone else and need to reconfigure the device to work
with your ISP;
• You are asked to perform a factory reset by NetComm Support staff
In order to restore your NB9WMAXX to its factory default settings, please follow these steps:
• Ensure that your NB9WMAXX is powered on (for at least 10 seconds);
• Use a paper clip or a pencil tip to depress the reset button for ten seconds and release. At this point, the
reset is in progress. Do not power off the unit at this point;
• When indicator lights return to steady green, reset is complete. The default settings are now restored.
The entire process takes about 45 seconds to complete;
• Once you have reset your NB9WMAXX to its default settings you will be able to access the device's
configuration web interface using http://192.168.1.1 with username 'admin' and password 'admin';
10 NB9WMAXX ADSL+ VoIP Router
YML89 Rev1