Back Panel Ports - NetComm NB9WMAXX User Manual

Internet
Red
Green

Back Panel Ports

Port Name
Antenna
4 x LAN
ADSL
Line
Power
Reset
NB9WMAXX ADSL+ VoIP Router
YML89 Rev1
On Device attempted to obtain an IP address and failed (no DHCP response, no PPPoE
response, PPPoE authentication failed, no IP address from IPCP, etc.) For bridged mode,
this LED remains off. If the IP or PPPoE session is dropped due to an idle timeout, the
LED will remain green if an ADSL connection is still present. If the session is dropped
for any other reason, the LED is turned off. The LED will turn red when it attempts to
reconnect and DHCP or PPPoE fails.
Off Modem is in bridged mode or ADSL connection not present.
Blinking IP connected and data is passing through the device (either direction)
Function
Wireless LAN antenna.
4 x 10/100 Base-T Ethernet jack (RJ-45) to connect to your Ethernet Network card or
Ethernet Hub / Switch.
Telephone jack (RJ-11) to connect to your Telephone Wall Socket (ADSL line).
Telephone jack (RJ-11) to connect to your Telephone Wall Socket (note you will
require an in-line splitter to split your telephone line if one wall point is used for both
your ADSL and telephone service).
Connect the power adaptor that comes with your NB9WMAXX.
Reset button. Depress for 10 seconds to return your NB9WMAXX to its default settings.
9