Wireless > Bridge; Wireless > Station Info - NetComm NB9WMAXX User Manual

Wireless > Bridge
Wireless bridge mode is used to provide a wireless link between WLAN segments to provide greater
coverage or to extend network size and reach. If a wireless router is used in bridge mode, then Access Point
functionality is disabled. Network Bridges operate to 'bridge' two network segments on the 'physical' or MAC
link layer. This section describes how to configure the NB9WMAXX in bridge mode.
To access the Wireless Bridge feature click on Wireless> Wireless Bridge:
Above, default setting for NB9WMAXX to act as Access Point.
Field Name
AP Mode
Bridge Restrict
Bridge Restrict disabled
Enabled (Scan)
Wireless > Station Info
This page shows the MAC address of authenticated wireless stations that are connected to the NB9WMAXX
and their status. In the example below there is one workstation attached to the wireless network.
NB9WMAXX ADSL+ VoIP Router
YML89 Rev1
Comment
Allows you to choose between Access Point or Wireless Bridge mode.
If AP Mode is set to Bridge, and this field set to Enabled, it allows you to specify from choice
of available bridge(s).
Any wireless bridge within range may connect.
Scans for available wireless bridges and displays MAC address of any that it has found.
Click 'Refresh' to initiate scan if required, then select bridge of choice.
1