Wireless Configuration - NetComm NB9WMAXX User Manual

Wireless Configuration

To enter advanced settings for the wireless network hosted by the NB9WMAXX, click on Wireless>Configuration:
Many of these fields may not need to be altered and may require interpretation by a network engineer.
Field Name
AP Isolation
Band
Channel
54gTM Rate
Multicast Rate
Basic Rate
8
About
'On': 'wireless clients associated with the access point will only be able to communicate
with the Access Point
'Off': wireless clients associated with the Access Point will be able to connect to each other
'peer-to-peer
[Not alterable by end-user]
The default channel is 11. The 802.11b/g network is divided into 14 channels in Australia.
Each channel broadcasts on a slightly different frequency; if you are getting interference
from adjacent wireless networks, make a note of the channels that these are operating on
and change your channel accordingly. For best compatibility, only use channel 1 to 11 as
some wireless client does not work on channel 12 and 13.
Default rate is 'Auto' and operates at the 54 Mbps data rate when possible but drops to lower
rates when necessary, dependent on signal strength and the capacity of the client stations.
Leave at default setting 'Auto' unless there is a specific requirement for multicast.
Leave as default
NB9WMAXX ADSL+ VoIP Router
YML89 Rev1