NetComm NB9WMAXX User Manual page 17

2. Click on the 'Voice' menu to access the VoIP setup page;
Note: Settings will vary from those shown below depending on your VoIP provider
3. Interface Name: Don't change the 'Interface name' setting;
4. Priority Codec: The priority codec is set to 'G729' which means your NB9WMAXX will firstly choose this
codec when communicating with your SIP proxy from your VSP (VoIP Service Provider);
5. Ptime: The 'ptime' is the time delay (milliseconds) between voice packets sent. Do not change this value
unless your VSP has asked you to;
6. SIP Proxy: Check the 'use SIP proxy' checkbox the enter the SIP Proxy IP address (issued by your VSP);
7. SIP Proxy Port: The default is port 5060, but your VSP may ask you to change this;
8. SIP Proxy Domain: In most cases this is the same value as the SIP Proxy IP address (check with your VSP
if unsure);
9. Register Expire Time: Default is 300 seconds. Don't change this value unless your VSP instructs you to;
10. DispName: This is the user-defined 'extension number' that will display on the other phone connected to
the NB9WMAXX;
11. VoIP Phone Number: issued by VSP
12. AuthID: same as above
13. Auth. Password: VoIP password issued by VSP
14. Once VoIP settings have been entered, click on Apply and Save all VoIP Parameters.
15. Once your SIP client has started, click on the 'Basic > Home' to see what the status of your Voice service is:
16. Pick up your telephone, make sure you have dial tone and can make a call.
Note: If you experience any failure in setting up your VoIP, please refer to the User Guide included on your CD ROM for more information.
NB9WMAXX ADSL+ VoIP Router
YML89 Rev1
1