Drum Refresh - Kyocera KM-2560 Advanced Operation Manual

System Menu

Drum Refresh

6-66
Refresh the drum when image blur or white spots appear on images in
copies.
There are 2 drum refresh modes.
Item
Drum Refresh 1
Drum Refresh 2
CAUTION:
Drum Refresh cannot be performed while printing. Execute
Drum Refresh after the printing is done.
To use [Drum Refresh 2], load 11 × 17" or A3 size paper into the Multi
Purpose tray.
When you run [Drum Refresh 2], the machine makes a vibrating sound for
about 90 seconds until drum refreshing is completed. The toner soiling on
the ejected paper is normal and does not indicate a fault.
Use the procedure below to refresh the drum.
1 Place 11 × 17" or A3 on Multi Purpose tray.
2
Press the System Menu key.
3
Press [ ], [Adjustment/Maintenance].
4 Press [Execute] of Drum Refresh 1 or Drum Refresh 2.
5 Press [Yes] to feed
paper to Multi
Purpose Tray and
start Drum Refresh.
6
Once Drum Refresh ends, return to the Adjustment/Maintenance screen.
Description
Use this mode when images are blurred or
smeared. Refreshing takes about 120
seconds.
Use this mode when white spots appear on
images. Refreshing takes about 160
seconds.
Adjustment/Maintenance
Drum Refresh 1: Execute
Auto Drum Refresh: Change
Standard
Drum Refresh will be started .
Are you sure?
Yes
Status
ADVANCED OPERATION GUIDE
Execute
Drum Refresh 2:
Execute
Main Charger Cleaning :
No
2/2
Return to Top Close
10/10/2007 10 :10