Output Destination - Kyocera KM-2560 Advanced Operation Manual

Output Destination

ADVANCED OPERATION GUIDE
You can use the procedure below to select an output destination such as
the optional document finisher for your copies.
NOTE:
Optional output destinations include the job separator, document
finisher and the built-in finisher.
The table below shows the available output destinations.
Destination
Top tray
Finisher Tray*
Job Separator Tray
* Copy output orientation can be selected either as face-up (print
facing up) or face-down (print facing down).
NOTE:
To change default destination for copies, refer to Output Tray on
page 6-20 for details.
Use the procedure below to select the output destination.
1 Press the Copy key.
2
Press [Org./Paper/Finishing] and then [Output Tray].
3
Select the output destination for finished copies.
When you select
[Finisher Tray],
select the
orientation of output
copy, Face Up (print
facing up) or Face
Down (print facing
down).
4
Press [OK].
5 Place the originals in the document processor or on the platen. Press the
Start key to start copying.
Description
Top tray of the machine (where copies are
stored)
Tray of the optional document finisher or built-in
finisher
Optional job separator
Ready to copy.
Output Tray
Press [ OK] to display
the image.
Top Tray Finisher Tray
Add Shortcut
Status
Copying Functions
1
Copies
1
Face Up
Face Down
Cancel OK
10/10/2007 10 :10
1-17