Drum Refresh - Kyocera ECOSYS M4125idn Operation Manual

Troubleshooting > Adjustment/Maintenance
3
Adjust as required.
1
Select [Start].
A pattern is printed. Check that the number "1" is printed at the bottom of the pattern.
2
As shown in the illustration, place the printed side down on the platen with the edge with the arrows toward the
back.
3
Select [Start].
The pattern is read and adjustment begins.
The second pattern is output.
4
Check that the number 2 is printed at the bottom of the pattern and repeat steps 2 to 3 once again to scan
pattern 2.
5
Select [OK] in the adjustment end confirmation screen.

Drum Refresh

Remove image blur and white dots from the printout.
NOTE
Drum Refresh cannot be performed while printing. Execute Drum Refresh after the printing is done.
1
Display the screen.
[System Menu / Counter] key > [Adjustment/Maintenance] > [Drum Refresh]
2
Adjust as required.
Select [Start]. Drum Refresh begins.
1 2
11-26