Kyocera KM-2560 Advanced Operation Manual page 301

ADVANCED OPERATION GUIDE
Criteria
Material
Dimensional accuracy
Squareness of corners
To avoid problems, use the Multi Purpose tray for transparencies and load
transparencies with the long side facing the machine.
If transparencies jam frequently at output, try pulling the leading edge of
sheets gently as they are ejected.
Hagaki
Before loading Hagaki into the
Multi Purpose tray, fan them
and align the edges. If the
Hagaki paper is curled,
straighten it before loading.
Printing onto curled Hagaki
may cause jams.
Use unfolded Oufuku Hagaki
(available at post offices).
Some Hagaki may still have
rough edges developed by a paper cutter on the back side. Remove any
such rough edges by placing the Hagaki on a flat surface and rubbing the
edges gently a few times with a ruler.
Envelopes
Use the Multi Purpose tray for envelopes.
Due to the structure of envelopes, printing evenly over the entire surface
may not be possible in some cases. Thin envelopes in particular may be
wrinkled by the machine in some cases as they pass through. Before
purchasing envelopes in volume, try testing a sample to ensure the print
quality.
Storing envelopes for a long period may cause them to become wrinkled.
Thus, keep the package sealed until you are ready to use them.
Keep the following points in mind.
Do not use envelopes with exposed adhesive. In addition, do not use the
type of envelope in which the adhesive is exposed after the top layer is
peeled off. Serious damage may be caused if the paper covering the
adhesive comes off in the machine.
Do not use envelopes with certain special features. For example, do not
use envelopes with a grommet for winding a string to close the flap or
envelopes with an open or film-covered window.
Specifications
Polyester
±0.7 mm
90° ±0.2°
Burrs
Burrs
Appendix-7