Original Size Selection - Kyocera KM-2560 Advanced Operation Manual

Sending Functions

Original Size Selection

2-2
Select the size of originals that will serve as the basis for scanning. Be sure
to select the original size when using originals of nonstandard sizes.
Choose the original size from the following groups of original size.
Item
Standard Select from
Sizes 1 automatic
detection and
standard sizes.
Standard Select from
Sizes 2 standard sizes
except Standard
Sizes 1 .
Others Select from
Hagaki and
Custom Original
Size *.
Size Entry Enter the size
that is not
indicated in
Standard Sizes
1 and 2**.
* Regarding the setting method of Custom Original Size (Custom 1 to
4), refer to Custom Original Size Setup on page 6-6.
** The input units can be changed in the System menu.
Refer to Switching Unit of Measurement on page 6-17.
Use the procedure below to select the original size when sending scanned
images.
1
Place the originals on the platen.
2 Press the Send key.
3 Press [Type of Original/Transmission] and then [Original Size].
Detail
Inch models: Auto, Ledger, Legal,
Letter, Letter-R, Statement,
Statement-R, 8.5×13.5", Oficio II-R,
11×15"
Metric models: Auto, A3, B4, A4,
A4-R, B5, B5-R, A5, A5-R, B6, B6-R,
A6-R, Folio
Inch models: A3, B4, A4, A4-R, B5,
B5-R, A5, A5-R, B6, B6-R, A6-R,
Folio, 8K, 16 K, 16K-R
Metric models: Ledger, Legal, Letter,
Letter-R, Statement, Statement-R,
8.5×13.5", Oficio II-R, 11×15", 8K,
16K, 16K-R
Hagaki, Oufuku Hagaki, Custom 1 to 4
Inch models
Horizontal: 2 to 17" (in 0.01"
increments), Vertical: 2 to 11.69" (in
0.01" increments)
Metric models
Horizontal: 50 to 432 mm (in 1 mm
increments), Vertical: 50 to 297 mm (in
1 mm increments)
ADVANCED OPERATION GUIDE
Size