Preface; General; Important Notes; About Fastmig Pulse Products - Kemppi FastMig MXF65 Operating Manual

1.

preFaCe

1.1

general

Congratulations on choosing the FastMig MXF equipment. Used correctly, Kemppi products
can significantly increase the productivity of your welding, and provide years of
economical service.
This operating manual contains important information on the use, maintenance and safety of
your Kemppi product. The technical specifications of the equipment can be found at the end
of the manual.
Please read the manual carefully before using the equipment for the first time. For your
own safety and that of your working environment, pay particular attention to the safety
instructions in the manual.
For more information on Kemppi products, contact Kemppi Oy, consult an authorised Kemppi
dealer, or visit the Kemppi web site at www.kemppi.com.
The specifications presented in this manual are subject to change without prior notice.

important notes

Items in the manual that require particular attention in order to minimise damage and
personal harm are indicated with the
their instructions.
1.2

aBOut FastMig pulse prOduCts

Kemppi FastMig™ MXF 65 and MXF 67 are wire feeders designed for demanding professional
use and intended for 300-mm wire spools. They can be used with both Fastmig Pulse and
Fastmig Synergic power sources.
Alternative panels for MXF 65 & 67 depend on the used power source i.e. Fastmig Synergic
becomes compatible by connecting SF 53 or SF 54 function panels with MXF wire feed
unit, and in the case of PF 65 function panel Fastmig Pulse power source can be connected.
Operation of wire feed units are controlled and adjusted by microprocessor. By adding
an optional synchronization unit (MXF Sync 65), SuperSnake sub-feeder device may be
connected to MXF 65 & 67.
This manual provides instructions on the start-up and use of the MXF 65 & 67 MIG/MAG wire
feeding units.
1.3

general saFety instruCtiOns

Kemppi welding equipments conform to international safety standards. Safety is an important
issue in equipment design and manufacturing. Therefore, Kemppi welding solutions are
unparalleled in safety. There are, however, always certain hazards involved in using welding
equipment. Therefore, to ensure your personal safety and the safety of your working
environment, carefully read the safety instructions below and respect them.
use of personal protective equipment
• The arc and its reflecting radiation damage unprotected eyes. Shield your eyes and
face appropriately before you start welding or observe welding. As the welding current
increases, the welding face screen lens darkness should also increase.
• Arc radiation and spatters burn unprotected skin. Always wear protective gloves, clothing
and footwear when welding.
• Always wear hearing protection if the ambient noise level exceeds the allowable limit
(e.g., 85 dB).
general operating safety
• Exercise caution when handling parts heated during welding. For example, the tip of
the welding torch or gun, and the end of the welding rod and the work piece. The
temperature of items burn unprotected skin.
notation. Read these sections carefully and follow
'NOTE!'
EN
3