Installation And Connection; Connection To The Drain; Connection To The Water Supply - Insinger RL-30 Technical Manual

INSTALLATION AND CONNECTION

!
WARNING:
Installation and connection of the washer to
the customer's water inlet, waste water
drainage and electric connections are to be
carried out in accordance with national and
local criteria by qualified engineers.
Check for Completeness:
After unpacking the machine, first check the delivery
against the packing slip to ensure that it is complete,
and inspect for damage that may have occurred
during transportation. Immediately report any
damage to the carrier, the insurance company and
the manufacturer.
Setting Up and Alignment:
When setting up the machine, remember that the
machine gives off steam during operation (when
you open the door). Protect adjacent wooden furni-
ture to prevent it absorbing moisture and swelling.
CAUTION:
Protect the washer against frost. Systems that carry
water can be damaged if they freeze.
The machine must be completely level when in-
stalled. Adjust the machine's feet to compensate
for any unevenness of the floor.
CAUTION:
Note all the information on the enclosed connection
diagram. For the machine to work correctly,
the required water pressure and flow rate must be
guaranteed at all time.

Connection to the Water Supply:

Use a ball valve and a pressure reducing valve
for the water supply and drain near the washer
and in an easily accessible position. It should
not be located behind the washer.
PRV should be set to supply 20 psi flow
pressure.
The washer is equipped with a drain pump.
The maximum drain pump lift above floor is 30".
Undercounter DOC RL-30 1.0 06
®
PART 2 INSTALLATION INSTRUCTIONS
Connection to the Water Supply
Connection should provide for a minimum of
24" (600mm) of flexible line at machine so that
unit can be moved for cleaning. Note: Unit is
provided with 37" (940mm) flexible connections.

Connection to the Drain:

Unit must be connected to drain capable of han-
dling 4.75 gal/min flow and must be provided with
a proper air gap at connection. Failure to provide
air gap will result in improper or inconsistent drain-
ing of unit and potential overflow condition. The
maximum height of the drain connection is 30".
Connection to the Power Supply:
Before using the washer, check that all electrical
protection systems are working correctly.
Attention: The machine should not be regarded
as isolated from the power supply unless
switched off at the customer's main switch.
The total amp load is 20 fla.
The electrical connection of the washer is to
be fused by the customer with time-lag fuses
or circuit breaker according to wattage (see
the machine rating plate). No other appliances
may be fused with the washer.
Install according to local regulations, this unit
requires a 30 amp circuit breaker in the electric
supply.
Connect the power cord to the customers
power system, make sure the unit is properly
grounded.
The power cord comes attached from the
factory, if replacement is needed it must be
done by certified personnel only.
Final Tasks:
The washer must be connected to all services
(electricity supply and to the fresh water and waste
water systems), prior to testing the machine & in-
stallation. Make sure incoming water line is flushed
of debris before connecting to unit.
9
www.insingermachine.com 800-344-4802
:
(continued)