Troubleshooting - Insinger RL-30 Technical Manual

TROUBLESHOOTING

Faults where it is not necessary to call Insinger.
You can rectify minor faults yourself following the
steps described in the table below. If you are un-
able to rectify the fault, contact Insinger service
(1-800-344-4802.)
Do not open any panels or expose any parts of the
machine if tools are necessary to do so. Risk of
electric shock.
Problem
Machine continues to fill
Machine fails to fill
Wash termperature incorrect
Rinse temperature incorrect
Machine continues to wash
Machine will not drain
Machine will not start
Undercounter DOC RL-30 1.0 06
®
A
There is no soil
Connections to
blocking the
pressure switch are
pressure switch
air tight and secure
opening in tub
Water supply to unit Solenoid valve is
is on operating properly
Verify door is Verify door switch is
closed functioning properly
Verify thermostat is
Adjust thermostat
working
Verify that the "de- Verify that the rinse
lime" switch is not temperature has
depressed reached its set limit
Verify proper
Verify drain pump is
settings on drain
functioning properly
delay timer (KA5)
Hold start switch for Verify S1 of cam
1 second timer is closed
PART 5 TROUBLE SHOOTING
Work on the electrical equipment should only be
performed by service personnel. First disconnect
the washer from the main power switch. Do not
switch the washer on again until the cause of the
fault has been identified.
!
WARNING:
Turn off the main switch on the dishwasher
so it is isolated from the power supply.
B
The pressure switch
is operating
Adjust thermostat
Verify contactor is
functioning properly
Verify relay KA2 is
working properly
Verify S2 of cam
timer is closed
14
www.insingermachine.com 800-344-4802
C D
Verify solenoid
valve is operating
properly
Verify thermostat is
working
Verify heater is
working properly
Verify cam timer is
working properly
Verify contactor
KM3 is energized