Range Hood Care; Clean The Exterior Surfaces; Clean Or Replace The Baffle Filters; Replace The Led Lamps - Awoco RH-C06-A-FC Owner's Manual

RANGE HOOD CARE

Cleaning
WARNING
• To reduce the risk of electrical shock, DO NOT
clean the hood while it's operating.
• Never put your hands into the area housing the
fan when the fan is operating.
Cleaning the Exterior Surfaces:
IMPORTANT
To avoid damage to the exterior surfaces:
• DO NOT use corrosive or abrasive detergent.
• DO NOT use steel wool, scoring pad or steel
brushes. Use a paper towel or soft cloth or
nonabrasive sponge instead.
• DO NOT use salt solutions, disinfectants,
bleaches or cleaning compound that contains
harmful chemicals.
Cleaning Method:
• Noncorrosive or nonabrasive liquid detergent
soap or all-purpose liquid cleanser.
• Wipe the surfaces with a damp paper towel or
soft cloth or nonabrasive sponge.
• Rinse with clean water.
• Wip dry with dry towel or cloth.
Note
• The nonabrasive stainless steel polisher can
be applied when done cleaning to retain the
stainless luster and grain.
• Always follow the instrunction of the polisher.
Cleaning the Stainless Steel Baffle Filters:
• Pull the spring release handle and remove the
filter by pulling it down.
• Wash the filters in the dishwasher, or soak it
into hot or warm water with dish detergent for
half an hour, then wipe the filter clean. Repeat
these steps until there's no oil residue remains.
• Let the filters dry thoroughly.
• Make sure the spring release handle is toward
the front, align and insert the filter.
10
• Pull the spring release handle and push the
filter into position.
• Release the handle.
• Repeat the steps for the remaining filters.
Cleaning the Oil Collector:
• Hold the oil collector at both ends and slide
it toward the user to detach it from the hood
body. Do this in reverse to install the oil
collector back to the slot after it's been cleaned
and dried completely.
• Wash the oil collector in the dishwasher,
or soak it into hot or warm water with dish
detergent for half an hour, then wipe the filter
clean. Repeat these steps until there's no oil
residue remains.
• Wipe off the excess water from the oil collector
and put it in a safe location to let it dry
completely.
Replacing the Filters
• Replace the baffle filters immediately should
they become worn out due to aging or
prolonged usage.
Replacing the LED Lamps
WARNING
Electrical Shock Hazard
Disconnect power before servicing
Wear gloves to protect against sharp edges
• This range hood uses 12V, 2W LED.
Contact Awoco customer service to get the
replacement LED lights.
• Unplug the range hood, or turn off the breaker.
• Remove the Baffle Filter adjacent to the Lamp.