Range Hood Care; Clean The Exterior Surfaces; Replace The Led Lamps - Awoco RH-IT Split Insert Series Owner's Manual

RANGE HOOD CARE

Cleaning
WARNING
• To reduce the risk of electrical shock, DO NOT clean
the hood while it's operating.
• Never put your hands into the area housing the fan
when the fan is operating.
Cleaning the Exterior Surfaces:
IMPORTANT
To avoid damage to the exterior surfaces:
• DO NOT use corrosive or abrasive detergent.
• DO NOT use steel wool, scoring pad or steel
brushes. Use a paper towel or soft cloth or
nonabrasive sponge instead.
• DO NOT use salt solutions, disinfectants, bleaches
or cleaning compound that contains harmful
chemicals.
Cleaning Method:
• Noncorrosive or nonabrasive liquid detergent soap
or all-purpose liquid cleanser.
• Wipe the surfaces with a damp paper towel or soft
cloth or nonabrasive sponge.
• Rinse with clean water.
• Wip dry with dry towel or cloth.
Note
• The nonabrasive stainless steel polisher can be
applied when done cleaning to retain the stainless
luster and grain.
• Always follow the instrunction of the polisher.
Cleaning the Stainless Steel Baffle Filters:
• Pull the spring release handle and remove the filter
by pulling it down.
• Wash the filter in the top rack of the dishwasher or
with warm soapy solution manually.
• Let the filters dry thoroughly.
• Make sure the spring release handle is toward the
front, align and insert the filter.
• Pull the spring release handle and push the filter
into position.
• Release the handle.
• Repeat the steps for the remaining filters.
10
Replacing the Filters:
• Replace the baffle filters immediately should they
become worn out due to aging or prolonged usage.
Replacing the LED Lamps:
WARNING
Electrical Shock Hazard
Disconnect power before servicing
Wear gloves to protect against sharp edges
• This range hood uses 12V, 3W LED.
• Unplug the range hood, or turn off the breaker.
• Remove the Baffle Filters and the Screws on both
sides.
• Flip the stainless steel Panel open on the longest
side, locate and disconnect the Wires for the LED
Lamps and the Control Panel.
LED Lamp Control Panel
Disconnect
the Wires
• Remove the old lamps and install new lamps.
• Connect the wires to the new Lamp.
• Align and put the new Lamp back into position.
• Press the edge of the new Lamp until it touches the
bottom of the Hood Unit.
• Put the Baffle Filter back into place.
• Plug in the range hood, or turn on the breaker.
• Check if the new Lamp is working properly.