Advertisement

Quick Links

OWNER'S MANUAL
Range Hood
RH-WQ Island Mounted Series

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RH-WQ Island Mounted Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Awoco RH-WQ Island Mounted Series

  • Page 1 OWNER'S MANUAL Range Hood RH-WQ Island Mounted Series...
  • Page 3: Table Of Contents

    Table of Contents Important Safety Instructions Installation Preparations Duct Venting and Accessories Tools Needed Venting Requirements Venting System Setup Duct Run Calculation Chart Electrical Requirement Installation Test Before Installing Prepare the Location Installing the Range Hood Connecting the Vent System Electrical Connection Installing the Baffle Filters Completing the Installation...
  • Page 4: Important Safety Instructions

    Important: Read and save these instructions. TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE: In case of this manual destroyed or lost, please visit https://www.awoco.com and download a digital • Never leave surface units unattended at high version. settings. Boilovers cause smoking and greasy spillovers that may ignite. Heat oils slowly on low WARNING or medium settings.
  • Page 5 IMPORTANT SAFETY INSTRUCTIONS TO REDUCE THE RISK OF PERSONAL INJURY IN THE EVENT OF A GAS LEAK: • Extinguish any open flame. • DO NOT turn on the lights or any type of appliance. • Open all doors and windows to disperse the gas. If you still smell the gas, call the gas company, fire department, or 911 immediately.
  • Page 6: Installation Preparations

    INSTALLATION PREPARATIONS DUCT VENTING AND ACCESSORIES: Venting Requirements: • For new installation or your old range hood • This range hood requires a venting system doesn't have an exhaust duct, prepare to cut the leading to outdoors. openings through the bottom of the cabinet, wall, • The venting system must not end in an enclosed top of the cabinet or ceiling, denpending on the area indoors. mounting type. A 6" round semi-rigid aluminim •...
  • Page 7: Venting System Setup

    INSTALLATION PREPARATIONS Venting System Setup: Measure and estimate the following figures before installation: • This range hood is 6" top venting through the roof or wall. • The distance between the countertop / stove to • Always use 6" round rigid or semi-rigid type the bottom of the range hood.
  • Page 8: Duct Run Calculation Chart

    INSTALLATION PREPARATIONS Minimum Duct Size: • The minimum mounting height should be no less than 24" and the maximum mounting height should be no more than 30". • Round: 6" minimum. • Also refer to the owner's manual of the stove top for the height clearance requirement and the recommended mounting height above the range.
  • Page 9: Electrical Requirement

    INSTALLATION PREPARATIONS IMPORTANT! Observe all governing codes and ordinances. It is the customer's responsibility: • To contact a qualified electrical installer; • To ensure that the electrical installation is in compliance with applicable codes and standards. Electrical Requirements: • A 120V, 60Hz., AC only, 15A fused electrical circuit is required. • Wire sizes and connections must conform with the power rating of the range hood and all applicable codes and standards.
  • Page 10: Installation

    INSTALLATION INSTALLATION INSTRUCTIONS NECESSARY TO INSTALL THE RANGE HOOD: • For electric ranges, unplug the power first before moving it. • For gas ranges, shut off the gas valve before moving it. CAUTION! Wear gloves to protect against sharp edges. Observe and prepare the location IMPORTANT! •...
  • Page 11: Electrical Connection

    INSTALLATION Installing the Baffle Filters not blocked by the ceiling. • Insert the screws into the holes and fasten them so that the mounting plate is securely mounted • Peel off the protective cover from the baffle filters to the ceiling. if there's any. • Remove the cover of the electrical box. •...
  • Page 12: Range Hood Use

    Range Hood Use Range Hood Control Panel F. Clock / Timer Display • When the Delayed Auto Shut-Off function is not activated, the (F) Clock / Timer Display will show the current time of the day. • THE CLOCK CAN ONLY BE SET WHILE THE BLOWER IS OFF. To set the Clock: • Touch the (B) Delayed Auto Shutoff button once. The hour Remote Control Sensor Light Indicator Speed Selection (-)
  • Page 13: Range Hood Care

    Range Hood Care easily overheat and catch on fire. The risk of • Make sure the spring release handle is toward self-combustion is higher when the oil has been the front, align and insert the filter. used several times. • Pull the spring release handle and push the filter • NEVER cook on “open” flames under the into position. range hood. Check deep-fryers during use: • Release the handle. Superheated oil may be flammable.
  • Page 14: Range Hood Troubleshooting

    Range Hood Troubleshooting Before Calling for Service Issue Possible Cause / Solution • Check if the range hood is plugged in. Make sure that all The range hood doesn't turn on power is turned ON, the fuse isn't blown and all electrical wirings are properly connected. The range hood turns on but •...
  • Page 15: Warranty

    To Receive Warranty Service: warranty period mentioned above, subject to the conditions and limitations set forth below, Awoco • Contact the seller or distributor from which you will, at our options, either repair or replace any purchase the product. Please confirm the terms...
  • Page 16 Website: www.awoco.com Customer Support: 1-888-412-3428...

Table of Contents