Installation Overview; Possible Tools Needed - Awoco RH-C06-A-FC Owner's Manual

Steps To Test Run Before Installation
IMPORTANT!
Wear gloves to protect against sharp edges.
PLEASE FOLLOW THESE INSTRUCTIONS TO TEST
THE RANGE HOOD BEFORE INSTALLATION FOR ANY
DEFECTS OR SHIPPING DAMAGE:
1. Remove the range hood and accessories from
the package carefully.
2. Place the range hood on a flat stable surface,
remove the baffle filter and check for any dents
or damages on the range hood body.
3. Remove the loosen parts if there's any.
4. Plug the range hood into a 120V AC power
source.
5. Check each speed variation and pay attention
to the noise level to make sure there isn't any
unusual noise besides it coming from the wind
blowing. Press the Light Button to check the
lights.
6. Verify all functions, as instructed in Page 9, are
working properly.
7. Refer to Range Hood Troubleshooting in Page
11 for general issues and solutions.
Please read all instructions carefully before
proceeding further to prevent the risk of fire,
electric shock, personal injury or damage to the
range hood. This manual provides a general insight
on the installation and may not include solutions
for all possible issues that may occur.
In case of this manual destroyed or lost, please
visit https:/ /awoco.com and download a digital
version.

INSTALLATION OVERVIEW

1. Unpack the range hood and check for any
physical damage on the body.
2. Test run the range hood and check if all
functions are working properly. Refer to Page 9
for functionalities.
STOP!
DO NOT install the range hood if it's defective.
Contact the seller immediately.
3. If all is fine, install the range hood as instructed
in this manual. Refer to Page 7 & 8.
4. Test run the range hood again when the
installation is finished. Refer to Page 11 for
troubleshooting.

POSSIBLE TOOLS NEEDED:

• Marker / Pencil;
• Jig Saw or Reciprocating Saw;
• Screwdrivers or Power Drill;
• Level;
• Measuring Tape;
• Knife:
• Duct / Foil Tape;
• Screws.
2 PEOPLE ARE REQUIRED FOR THE INSTALLATION.