HP Kayak XA User Manual page 151

crystal.bk : cryst-4.fb4 Page 135 Monday, March 23, 1998 4:09 AM
4 The External 16/8-bit Symbios BIOS and the FastRAID BIOS cannot
be loaded at the same time in BIOS setup. The Symbios BIOS should
be disabled (from the
window, disable
16/8-bit SCSI
fixed in a later version of the BIOS. Check the World Wide Web at the
following site:
http://www.hp.com/go/
to see if this has been corrected.
kayaksupport/
Consequence: you cannot boot from devices connected to the
Symbios controller at the same time as Wide SCSI devices. It is,
however, possible to manually switch from bootable SCSI devices,
connected to the Symbios controller, to Wide SCSI devices.
5 Ensure that you boot from the Windows NT diskettes provided and
not from the CD-ROM. If you boot from the CD-ROM, the hard drive
will not be found (problem relating to Windows NT).
6 Ensure that the FastRAID/Array1000 drivers are installed. To install
these drivers:
a Shut down your PC Workstation, remove the ARO-1130 adapter,
and restart your system.
b Click the Start menu, point to Settings, and then click Control
Panel.
c Double-click the SCSI Adapters icon, then the Drivers tab.
d Click Add, Have Disk..., and insert the Adaptec Array1000 driver
diskette.
e When requested to enter the driver path, type A:\winnt and
follow the installation instructions (the Windows NT 4.0 CD-ROM
may be needed).
f Shut down your computer and re-install the FastRAID card.
Advanced/External and Internal Wide
Option ROM Scan
4 Technical Information
Using the ArrayConfig Program
). This may be
English 135