HP Kayak XA User Manual page 140

crystal.bk : cryst-4.fb4 Page 124 Monday, March 23, 1998 4:09 AM
Installing Windows
NT 4.0
NOTE
4 Technical Information
Using the ArrayConfig Program
8 When the next menu appears, select a boot order for the new array.
Select
•
Disk Array will be Boot Drive
from the new array. If you selected
Step 4, booting from an array safeguards the information on your
boot drive.
Select
• Disk Array will not be a Boot Drive
computer to boot from the new array. (If you only have one array,
it will automatically be the boot drive.)
9 When you have finished all these menu selections, wait while
ArrayConfig creates the array. This may take up to 30 minutes,
especially if the disk drives are large.
A message appears when the array has been created. An error
message appears if the ArrayConfig encounters some problems (for
example, an array already exits). If this happens, run ArrayConfig
again and use the Custom Setup option.
10 Press until you're back at the Main Menu, and exit ArrayConfig.
11 Begin the installation of Windows NT 4.0 by booting from the floppy
diskettes you made before creating your array.
Do not boot from the Windows NT CD-ROM as the hard drive will not be
detected.
12 When prompted, insert your drivers diskette into drive A and
press . When the driver has finished loading, you can
continue with the Windows NT installation. For more information,
refer to your operating system's documentation on your Drivers
CD-ROM.
124 English
if you want your computer to boot
Optimized for Data Protection
if you do not want your
in