HP Kayak XA User Manual page 71

crystal.bk : cryst-2.fb4 Page 55 Monday, March 23, 1998 4:09 AM
Completing the
Installation of a
Processor
NOTE
NOTE
1 Verify that the system board bus speed switches are correctly
configured for the processor.
If two processors are installed, both must operate at the same bus speed
and processor speed. Refer to the manual supplied with the processor
to verify which bus and processor speeds are supported.
Switch 1 Switch 2 Switch 3
1
UP UP UP
UP UP DOWN
UP UP DOWN
UP UP DOWN
1. UP=OFF, DOWN=ON.
2 Install any other accessories before completing the installation of the
processor.
3 Replace the cover (see page 27).
4 Turn on the computer and check that the new processor is
recognized by the power-on system-test.
To fully benefit from dual processing, you will need to re-install
Windows NT 4.0 on your PC Workstation.
2 How to Install Accessories Inside Your PC Workstation
Switch 4 Switch 5 External
Bus Speed
DOWN DOWN 100 MHz
UP UP 100 MHz
UP DOWN 100 MHz
DOWN UP 100 MHz
Installing a Processor
Processor
Speed
350 MHz
400 MHz
450 MHz
500 MHz
English 55