crystal.bk : cryst-4.fb4 Page 105 Monday, March 23, 1998 4:09 AM
NOTE
ATTENTION
Configuring a SCSI Accessory
There are two ways to configure a SCSI accessory:
SCSISelect — for use with Internal Wide 16-bit SCSI devices
•
& HP FastRAID (Adaptec).
SCSI Configuration Utility — for use with External and Internal
•
16/8-bit SCSI devices (Symbios).
You cannot boot from a device connected to the Symbios controller
when HP FastRAID is installed.
To disable a boot device:
1 Go to the
Advanced
2 Select the SCSI channel you wish to set.
3 Enable or disable the
Using SCSI Select
™
The SCSISelect
utility is intended for advanced users only.
Note that the SCSISelect options displayed on your screen may
be different from those described here. Some options are not
displayed if the HP FastRAID option is installed.
The SCSISelect utility is accessed by pressing
computer's start-up process when the message
SCSISelect(TM) Utility!
menu in the Setup program.
as required.
Option ROM Scan
Press
is displayed.
4 Technical Information
Configuring a SCSI Accessory
during the
for
English
105