Configuring A Scsi Accessory Using Scsiselect - HP Kayak XW A2-U2-W2 User Manual

ATTENTION
Viewing the Options
menu

Configuring a SCSI Accessory Using SCSISelect

™
The SCSISelect utility is intended for advanced users only.
Note that the SCSISelect options displayed on your screen may
be different from those described here. Some options are not
displayed if the HP FastRAID option is installed.
The SCSISelect utility is accessed by pressing
computer's start-up process when the message
SCSISelect(TM) Utility!
When you run the SCSISelect utility, you may first see a screen asking
you to select a bus and device. Select either
Ultra-wide SCSI (16-bit) or
then press
channels are enabled through HP Setup (and does not appear if the
FastRAID option is installed).
Next, the Options menu is displayed.
Would you like to configure the host adapter, or run the
SCSI disk utilities? Select the option and press <Enter>.
Press <F5> to switch between color and monochrome modes.
Configure/View Host Adapter Settings
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit
Use the and
the SCSISelect utility. Press
menu.
Configuring a SCSI Accessory Using SCSISelect
is displayed.
to configure Ultra SCSI (8-bit), and
00:09h
. This screen does not appear unless both SCSI
SCSISelect(TM) Utility v1.xxx
Options
SCSI Disk Utilities
keys and the
at any time to return to the previous
4 Technical Information
during the
Press for
to configure
00:08h
key to make selections in
English 99