Gestetner P7245 Hardware Manual page 505

B
Confirm that the printer is turned
off, and the power cord is un-
plugged from the wall outlet.
C
Remove the tape that holds the
paper feed unit, and then remove
the packing material.
Do not remove the tape that holds
the connector cable inside the con-
nector cover on the back of the pa-
per feed unit in this step. It is
removed in the further step.
D
Align the printer with the two up-
right pins on the paper feed unit
and then lower the printer slowly.
• The printer should be held by
least two people.
• When lifting the printer, pull
out the grips from the front of
the printer. One person should
hold the grips on the front and
another person should hold the
grips on the rear.
E
Push the grips into the printer.
Take out the cover inside Tray 2
and attach it between the paper
AQV041S
tray and the front cover.
AQV040S
F
Pull the second paper tray (Tray 2)
until it stops. After that, lift it
slightly, and then pull it out.
AQV007S
AQV003S
AQV001S
2
AQV732S